Heating Repair in Denton, TX
A heater that will not start, blows cold air, or shuts off too soon needs attention before the next cold front. Harlen Johnson HVAC, Plumbing & Electrical repairs furnaces and heat pumps in Denton, TX, and explains what failed and why before any work begins.
Common Heating Problems We Repair
| Problem | Likely causes |
|---|---|
| No heat | Thermostat, igniter, flame sensor, breaker, or control board |
| Cold air from vents | Failed igniter, gas supply issue, or heat pump in defrost failure |
| Short cycling | Dirty flame sensor, overheating, or oversized equipment |
| Burning smell that lingers | Overheating motor or electrical problem |
| Loud noises | Blower motor, inducer motor, or loose panels |
| High bills | Dirty filter, failing heat pump, or backup heat running too often |
| Furnace locks out | Pressure switch, venting, or flame sensing problem |
Furnace Repair
Gas furnaces rely on a series of safety checks before they light. If one fails, the furnace shuts down. We test igniters, flame sensors, pressure switches, limit switches, inducer motors, gas valves, and control boards to find the exact cause.
Heat Pump Repair
Heat pumps heat by moving warmth from outside air into the home. When they fail, it is often a defrost problem, a reversing valve, a failed capacitor, or low refrigerant. We also check the backup heat strips, which can drive up electric bills if they run too often.
Electric Furnace Repair
Electric furnaces use heating elements controlled by sequencers or relays. Burned elements, failed sequencers, and loose high-voltage connections are common causes of weak heat.
What to Do Before Calling
- Check that the thermostat is set to heat and the batteries are good
- Replace a dirty filter
- Check the breaker
- Make sure the furnace door is fully closed, since many units will not run with it open
If you smell gas, leave the home immediately and call 911 or the gas utility from outside.
Our Heating Repair Process
- Review the symptoms and system history
- Inspect and test components
- Check safety controls and venting
- Explain the problem and price the repair
- Complete the repair and test the system through a full heating cycle
Repair or Replace Your Heater?
Repair usually makes sense for a newer system with a single failed part. Replacement may be the better choice if the furnace is 15 to 20 years old, has a cracked heat exchanger, or needs frequent repairs. We will give you both options when it makes sense.
Heating Repair for Older Denton Homes
Older homes may have furnaces in closets, attics, or garages with tight access, and vent pipes that have been modified over the years. We pay attention to venting, clearances, and gas connections when diagnosing these systems, since safety issues can be easy to miss in older installations.
Heat Pump Backup Heat and High Bills
If your heat pump is running on backup heat more than it should, your system may still feel like it is working, but your electric bill will show the difference. Common causes include low refrigerant, defrost problems, a failing outdoor fan, or a thermostat that calls for backup heat too early. Fixing the cause often lowers winter bills significantly.
Carbon Monoxide Safety
Every home with gas appliances should have working carbon monoxide alarms near sleeping areas. If an alarm sounds, leave the home and call 911 or your gas utility from outside. Do not return until it has been declared safe. A furnace with a cracked heat exchanger, blocked flue, or disconnected vent should not be operated until it is repaired or replaced.
How Much Does Heating Repair Cost?
Cost depends on the part and the labor involved. Flame sensor cleaning and igniter replacement are typically less expensive than an inducer motor, control board, or gas valve. You will receive pricing before work begins.
Current HVAC Specials in Denton, TX
| Special | Details |
|---|---|
| $750 off | New AC & heating system package |
| $250 off | Whole-home air duct cleaning |
| $250 off | Whole-home air purification system |
| $25 off | Any service for new clients |
| 10% off | Repair or maintenance for veterans, seniors, and teachers |
Terms and eligibility apply. Mention the special when you call 972-241-7771 to schedule.
Frequently Asked Questions About Heating Repair in Denton
It may be in the fan-only setting, the igniter may have failed, or a safety switch may be shutting off the burners. A technician can test the sequence to find the cause.
Repeated shutdowns are often triggered by safety controls. Have the system checked rather than resetting it again and again.
We service most major brands. Share the make and model when you call.
Many repairs are completed in one visit. Some parts may need to be ordered.
Schedule Heating Repair in Denton, TX
By clicking “Submit”, you authorize Harlen Johnson HVAC, Plumbing & Electrical to contact you by phone, email, and text message at the number and email address you provide. Text messages may include responses to your inquiry, appointment updates, and promotional messages. Message frequency varies. Message and data rates may apply. Consent to receive text messages is not a condition of purchase. You can opt out of text messages at any time by replying STOP or get help by replying HELP or calling us at 972-241-7771.
View our Privacy Policy for more details.
Schedule a Service